Architectural Information:
Fan forced electric air heaters shall be UL Listed, factory rated at 120V, 208V, and dual field rated 208V/240V. A painted 20 gauge wall mounting can with six knockouts and 34 cubic inch wiring compartment shall be provided with each complete heater. Each complete heater shall be of unitized construction and attach to the wall can with a single screw and shall be self-contained and completely separate from the wall mounting can. Element is of nichrome type wire wrapped on mica insulators with an oversized 16 amp rating at 240V, high temperature manual power reset limit switch and an over-temperature thermal back-up fuse. A two stage centrifugal blower shall be driven by an impedance protected motor. The motor shall be totally isolated from the heating chamber. Metal grill shall be of one piece, 20-gauge construction and finished with a powder coat paint system.

Technical Information:
Fan heaters and thermostats work best when installed on an inside wall. UL requires heater to be placed a minimum distance of 6” from adjacent surfaces and 4½” from the floor. Manufacturer recommends installation 12” from all surfaces. All models 1500 watts or less may be ceiling mounted. A 3’ (91.44cm) minimum clearance is recommended for furniture or other objects placed directly in front of heater.

NOTE: Manufacturer recommends installing heater assembly after walls are finished. Heater must be cleaned every six months minimum.

Ordering Information:
Suffix "T” in model number denotes built-in single pole thermostat. Model numbers without a “T” require a thermostat. Recommended for elevations under 10,000 feet. Complete unit available in white only.


Rough In Dimensions: 8"W x 10.25"H x 4"D
Wall Can Dimensions: 7.875"W x 11.5"H x 4"D
Grill Dimensions: 9"W x 12"H