Architectural Information:
Fan forced electric air heaters shall be UL Listed and factory rated at 120V. Each complete heater shall be of unitized construction and attach to the wall can with four screws and shall be self-contained and completely separate from the wall mounting can. Element is of nichrome type wire wrapped on mica insulators with a high temperature manual power reset limit switch and an over-temperature thermal back-up. A two stage centrifugal blower shall be driven by an impedance protected motor. The motor shall be totally isolated from the heating chamber. Grill assembly is made up of stamped grill and attached expanded metal screen. Grill trim frame is made of stainless steel.

Technical Information:
For best results use a timer control with the RBF heater. UL requires a minimum clearance of 6” from adjacent vertical surfaces such as walls, shelving, drapes, etc., and 6” from the floor. Manufacturer recommends 12” from finished floor and adjacent surfaces. A 3’ minimum clearance is recommended for furniture or other objects placed directly in front of heater.

NOTE: Manufacturer recommends installing heater assembly after walls are finished. Heater must be cleaned every six months minimum.

Ordering Information:
Recommended for elevations under 10,000 feet. Stainless steel grill attaches with frame.

Replacement unit only, wall can not available. For new installations, see our Com-Pak Bath Heater with built-in timer.


Rough In Dimensions: 10.25"W x 17"H x 4"D
Wall Can Dimensions: 10.125"W x 18"H x 3.875"D
Grill Dimensions: 12"W x 19"H x .25"D