Architectural Information:
Fan forced electric air heaters shall be UL Listed, factory rated at 208V or dual field rated 208V/240V. A painted 20 gauge wall mounting can with four knockouts and 79 cubic inch wiring compartment shall be provided with each complete heater. Heater shall be of unitized construction and attach to the wall can with two screws and shall be self-contained and completely separate from the wall mounting can. Two elements shall be nichrome type wrapped on mica insulators with two oversized 16 amp at 240V high temperature manual power reset limit switches and two over temperature thermal backup fuses. Two independent two-stage centrifugal blowers shall be driven by impedance protected motors. The motors shall be totally isolated from the heating chamber. Metal grill shall be of one piece, 20 gauge construction and finished with a powder coat paint system.

Technical Information:
Model may be ordered with or without built-in thermostat. For optimum comfort a Cadet electronic thermostat may be used (check amperage rating). Single pole and double pole field mount thermostat kits available. Fan heaters and thermostats work best when installed on an inside wall. UL requires heater to be placed a minimum distance of 6” from adjacent surfaces and 4.5” from the floor. Manufacturer recommends installation 12” from all surfaces. A 3’ (91.44cm) minimum clearance is required for furniture or other objects placed directly in front of heater.

NOTE: Manufacturer recommends installing heater assembly after walls are finished. Heater must be cleaned every six months minimum.



Rough In Dimensions: 14.675"W x 10"H 4"D
Wall Can Dimensions: 14.5"W x 11.125"H x 4"D
Grill Dimensions: 16.25"W x 12"H x 1"D