Architectural Information:
Fan forced electric air heaters shall be UL Listed, factory rated at 120V, and dual field rated 208V/240V. The elements and blower shall be of unitized construction and attach to wall can with four screws. Elements shall be of nichrome type with an oversized 25 amp at 240V high temperature manual reset limit switch. A blower delivering approximately 65 CFM shall be driven by an impedance protected motor. The motor shall be totally isolated from the heating chamber. Metal grill shall be of one piece, 22 gauge construction and finished with a powder coat paint system. A painted 22 gauge wall mounting can with 2 knockouts and 70 cubic inch wiring compartment is also available.

Technical Information:
All models come with a built-in double pole thermostat. Fan heaters work best when installed on an inside wall. UL requires heater to be placed a minimum distance of 6" from adjacent surfaces and 6" from the floor. Manufacturer recommends installation 12" from all surfaces. A 3' (91.44cm) minimum clearance is required for furniture or other objects placed directly in front of heater.

NOTE: Manufacturer recommends installing heater assembly after walls are finished. Heater must be cleaned every six months minimum.



Rough In Dimensions: 14.625W x 10H x 4D
Wall Can Dimensions: 14.5W x 11.125H x 4D
Grill Dimensions: 16.75W x 12.875H x 1"D